![]() ![]() Those blocks are the reason your work did not fall over ahead of time. Then you just erase the blocks connected to the top block by the pegs. Step 3, when you have added plenty of weight to the opposite side of the pole, then you must add some more weight so as to make sure it tips over on that side. (red object side goes down, Flag side goes up, add weight to the flag side until block is level, then you just continue on.) ![]() ![]() Second, you add the hinges, and then make a chain, and connect the final block to the red object.Ī note: if the top rectangle object is starting to tip over by alot, then you have to add some weight to the opposite side. These are important BECAUSE they are needed to keep your block You start on these first after drawing the rectangle and putting on a pin. On the pins, you attach a long block that will be running alongside the pole. DO NOT CONNECT IT TO THE POLE if it is possible.įrom the left to the right of the block you have: end of block, hinge, pin, pole, pin, hinge, end of block. To help, you need to make the block going over the pole a long rectangle (make it so it is like a T), and that block will have two hinges and two pegs, one on each end. (you know, chains leading from the red object to the other side over a pole and add a weight to the opposite side). One method that has helped me tons is a weighted sling shot over a tall pole. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |